42
EN
PLAYER
Knowledgesections
In case of difficulty
The BATT.ON/OFF switch is set to [OFF]: Slide it to [ON].
The built-in battery is exhausted: Connect the AC adaptor to recharge the battery.
✍ [Recharging of the built-in battery] $
The hold mode is set: Slide the HOLD switch to release the hold mode.
✍ [Names and functions of parts] 9
The player is connected to the PC: The operations performed on the player are defeated while it
is connected to a PC.
The battery is degraded: Replace it with new one.
(For the replacement of the built-in battery, contact your dealer.)
There is no audio data stored in the player: Transfer audio data in the player using the
application software Kenwood Media Application or Windows Media Player.
✍ [Kenwood Media Application] INSTRUCTION MANUAL
[Transfer of audio data from the PC to the player] &
The headphones are connected improperly: Check the connection of headphones to the player.
✍ [Playback of audio data] ^
The volume is set to the minimum: Adjust the volume.
✍ [Adjusting the volume] (
The BATT.ON/OFF switch is set to [OFF]: Slide it to [ON].
✍ [Recharging of the built-in battery] $
The AC adaptor is connected improperly: Check the connection of the AC power cord and power
cord to the player.
✍ [Recharging of the built-in battery] $
The ambient temperature is outside the operating temperature range: The battery should be
recharged within the operating temperature range.
✍ [Operating Precautions] 4
The player stops recharging automatically in order to prevent the temperature from rising. This
is not malfunction: Wait a while until recharging restarts.
The PC and the player are connected improperly: Check the connection between them.
✍ [Recharging of the built-in battery] $
The power of the player is turned off: Turn on the player.
✍ [Turning the player on/off] ^
The player cannot be turned on
or operated by pressing a button.
The built-in battery runs out
quickly after recharging.
Playback is impossible.
Audio is not heard.
The recharging icon is not
displayed.
The recharging icon disappears
while the AC adaptor is con-
nected.
The PC does not recognize
the player.
Symptom Remedy
7
Resetting the player
The player may malfunction (impossibility of operation, erroneous display, etc.) after a connection cord is unplugged
during use or due to an external factor. If this happens, reset the player as described below.
2
Set the BATT. ON/OFF switch to [OFF], wait for about 5 seconds, and set the switch again to [ON].
When the BATT. ON/OFF switch is set to [OFF], the following setups are reset to the defaults.
¶ TIMER SETTING
¶ DATE/TIME
1
Disconnect the AC adaptor from the player.
POINT :
Even when the player is reset, the audio data in the built-in HDD is not deleted.
