A SERVICE OF

logo

Open as PDF
next previous
ACRO 33
existing model number
CLR key to start
stand-by receiving
+ or - to select models
model number to
be copy
Receiving counter (0-100%)
When there is a data receiving failure during transmitting, the
counter will stop. At this time, press the CLR key to stop the
receiving condition. Check to be sure the receiving counter is
operating normally and ended with 100%. If there is any failure
of transferring, the display will appear as follows:
3.10 Data Transfer, cont.
stand-by
condition
receiving
counter
0-100%
stand-by receiving condition
To wing type
selection function
To modulation
select function
DN
SELECT
CH CH CLEARUP
Transmitting/Receiving
mode select
Press to start
transmitting
When the receiving counter is stopped or you see ERROR
indicated, check the DSC cord connections or trainer cord
conditions and try again. When data has been received
correctly, you will see [End ok!] display. Be sure that the
receiving mode transmitter is in stand-by condition first. Then on
the transmitting transmitter press the CLR key to start transmitting.
Also ensure that when transferring is complete, previous data
stored in the receiving side transmitter is replaced by the new
data transferred.
Note: This function does not work when the battery alarm is
flashing (low battery).
Receiving
model select
Press to standby
receiving/stop
receiving condition
DN
SELECT
CH CH CLEARUP
To Wing Type
selection function
To Modulation
select function
Transmitting/
Receiving Mode
change