Invacare L-3X Manual

A SERVICE OF

next previous

SECTION 10—BATTERIES

Lynx™L-3X 36 Part No. 1145807

3. Ifnecessary,connectthebatterycable.RefertoConnecting/DisconnectingtheBattery

Cablesonpage 37.

4. Removetheseat.RefertoRemoving/InstallingtheSeatonpage 27.

5. Liftinguptoreleasethehookandloopstrips,removetherearshroudfromthescooter.

6. Performthefollowingtoinstallabatteryfromthebatterytray:

A. Withthebatteryterminalsfacingtowardsthecenterofthescooter,positionthe

batteryontothebatterytray.

B. Positionthehookandloopfasteningbatterystraparoundthebatteryandtosecure

thebatterytothebatterytray.

7. RepeatSTEP6toinstalltheremainingbatteryintothebatterytray.

8. ConnectthetwoGRAYbatteryconnectorstothewiringharnessconnectors.

9. Aligntabsontherearshroudwiththeslots(notshowninfigure)in

thefrontshroud.

10. Placerearshroudontheframeandpressdownslightly.

11. Reinstalltheseat.RefertoRemoving/InstallingtheSeat

onpage 27.

NOTE:NewbatteriesMUSTbefullychargedbeforeusing,otherwisethelifeofthebatterieswill

bereduced.

FIGURE 10.2 Removing/Installing the Batteries

Strap

Batteries

Battery Wiring Harness Connectors

Battery

Connectors