Invacare 1073955 Manual

A SERVICE OF

next previous

SECTION 7—SEAT AND BACK

Orbit

™

54 Part No. 1073955

Removing Adjustable Angle Stroller Handles

1. Remove thetwomountingscrewsthatsecuretheadjustableheightstrollerhandleto

thebackcanes.

2. Remove theadjustableanglestrollerhandlefromthebackcane.

3. Installbackcanegripsand/orplugbuttons.

FIGURE 7.3 Installing Adjustable Angle Stroller Handles - Removing Adjustable Angle Stroller

Handles

Adjusting Adjustable Angle Stroller Handles

NOTE:Forthisprocedure,refertoFIGURE 7.4onpage55.

NOTE:Strollerhandlesadjustinthesamemannerforreclinerandnon‐reclinermodels.

1. Flipbothreleaseleverstotheunlockedposition.

2. Adjuststrollerhandletodesiredheight.

3. Flipbothreleaseleverstothelockedposition.

4. Pushdownonstrollerhandletoensurereleaseleversholdthedesiredpositionofthe

strollerhandle.

5. IfreleaseleversDONOTholdtheposition,tightenthereleaseleverbyperformingthe

following:

A. Flipreleaselevertotheunlockedposition.

B. Rotatethumbscrewclockwiseonerevolution.

NOTE:Whentighteningthereleaselever,thereleaselevermustbeabletoclose

completelyinto

thelockedposition.Otherwise,thereleaseleverswillnotholdthedesiredangle

C. Flipreleaselevertolockedposition.

NOTE:Ifthereleaseleverdoesnotclosecompletelyintothelockedposition,rotatethe

thumbscrewcounterclockwise1/2revolution.

D. RepeatSTEPSA‐Cforoppositereleaselever.

E. Pushdownonstrollerhandletoensurereleaseleversholdthedesiredpositionof

thestrollerhandle.

F. RepeatSTEPSA‐Euntilreleaseleversholdtheposition.

Stroller Handle

Mounting

Screw

Locknuts

Back

Canes

Mounting

Screw

NOTE:Backcanegripsand

plugbuttonsnotshownfor

clarity.