3-12 Installation and Service Guide
Disk Drive (SCSI-Attached): Models 340, 34H, 350, 355, 360/36T,
365, 370/37T, 375
Reference to the Small Computer Systems Interface (SCSI) Input/Output controller is
abbreviated as SCSI I/O controller in this publication.
Note: Refer to “Handling Static-Sensitive Devices” on page 3-2 before removing or
installing drives in this system.
Removal
1. Set the power switches of the attached devices to Off.
2. Set the power switch of the system unit to Off.
3. Disconnect the power cable.
4. Do the removal procedure in “Rear Cover” on page 3-3.
5. Do the removal procedure in “Top Cover” on page 3-4.
6. If a front drive is installed, disconnect the power supply connector (P4) from the front
drive.
7. Pull the frame latch forward.
8. If a drive is installed in the rear position, partially pull the frame up and disconnect the
power supply connector (P3) from the rear drive.
9. Remove the frame assembly.
10. Using the pull loops, remove the SCSI cables from the disk drives.
11. Remove the disk drive from the frame (four screws in each drive).
12. Remove the two screws from the riser card.
13. Slide the riser card out.
LatchFrame
Assembly
P4P3
SCSI
Cable
Disk
Drives
