Removal and replacement procedures 46
o
Full-height
To replace the component, reverse the removal procedure.
IMPORTANT: Be sure to connect the right-angle end of the SATA data cable to the system
board. Connecting it to the SATA drive may interfere with other installed media bay devices.
IMPORTANT: If both SATA and PATA optical devices are installed simultaneously, only one
can boot at a time. Boot priority will go to SATA if media is inserted into the SATA optical
drive. Boot priority for PATA is not configurable. To boot PATA, remove the media from the
SATA optical device, or remove the SATA optical device.
Heatsink
To remove the component:
1. Power down the server (on page 27).
2. Do one of the following:
o Unlock and remove the bezel ("Front bezel" on page 29).
o Extend the server from the rack (on page 28).
3. Remove the access panel.
4. Disconnect the heatsink fan cable from the system board.
5. Open the heatsink locking levers.
