A SERVICE OF

logo

Removal and replacement procedures 36
6.
Remove the four T-15 screws and slide the hard drive cage out of the chassis.
7. Remove all hard drives.
To replace the components, reverse the removal procedure.
NOTE: When replacing or installing a 6-bay hard drive cage, connect the 10-pin power cable
from the power backplane to the 8-pin power connector on the hard drive cage backplane.
When seated properly, the connectors have a two-pin overlap. The overlap is cosmetic only
and causes no functional side effects.
Air baffle
To remove the component:
1. Power down the server (on page 27).
2. Do one of the following: