A SERVICE OF

logo

Open as PDF
next previous
32
Setup
2
Compare the current color density settings on the Color Calibration
Page with the color density samples on the Color Calibration
Reference to see if they match.
Place the Color Calibration Page on at least 2 sheets of clean white paper in a
well-lighted area.
10
10
10
10
If they match, you do not need to adjust the color density. If they do not match, go to step
3.
3
Press the + key until the message display shows >Cyan. The current
density setting for cyan is indicated (the default is 10).
(1) Press the ENTER key.
>Cyan
10
(2) Press the + or - key to darken or lighten the cyan color.
For example:
• If you wish to make the density setting darker:
– Press the + button (up to 20).
• If you wish to make the density setting lighter:
– Press the - button (to 00).
(3) Press the ENTER key.
Color Calibration
Reference
Color Calibration
Page