A SERVICE OF

logo

MEDTESTER 5000C FIELD UPGRADE INSTALLATION INSTRUCTIONS
10
7.
To install more than one module, repeat steps seven (7) through nine
(9) for each module which has an installation disk. Install them in
numerical order.
8. If necessary, return to Windows from Command Prompt by typing:
EXIT<Enter> at the DOS prompt.
Confirming Module Installation
1. Turn the medTester 5000 power off to reset the microprocessor.
2. Turn the medTester 5000 power on. Check that the startup message
shows the correct instrument serial number and the correct firmware
version number.
3. Push F5 UTIL, then right arrow, then F3 MODULES. At this point, each
press of F5 NEXT will sequentially scroll through each installed module
allowing you to confirm the modules installed in the medTester 5000.