Maintaining the Test Tool
Using and Adjusting 10:1 Scope Probes
2
41
7. Install a new battery pack.
Note
Ensure that the battery pack is placed in the
battery compartment as shown in Figure 2-2. Use
only the Fluke BP120 Ni-Cd battery pack.
8. Reinstall the battery cover and secure the screw.
Using and Adjusting 10:1 Scope Probes
You need to adjust the red and gray scope probes
(PM8918, optional) for optimal response.
Warning
To avoid electrical shock use the BB120
Banana-to-BNC adapter (delivered with the
test tool) to connect a 10:1 scope probe to
the input of the test tool.
To adjust probes, do the following:
• Connect the 10:1 scope probe from the gray input B
jack to the red input A jack. Use the red 4-mm
banana adapter (delivered with the probe) and the
banana-to-BNC adapter (BB120). See Figure 2-3.
Figure 2-3. Adjusting Scope Probes
