Installing RTM-ATCA-7350 Hardware Preparation and Installation
RTM-ATCA-7350 Installation and Use (6806800H30F)
31
The blue LED blinks indicating that the shelf manager is informed about the desire
of the blade to power down the payload of the front blade and the power-down
process is ongoing.
3. Wait until the blue LED of the front blade is permanently ON. A permanently
switched ON LED indicates that the payload of the front blade has been powered
down.
4. Remove the front blade. For instructions on how to remove the blade, refer to
Section 2.7.2.2 Removing the ATCA-7350 in ATCA-7350 Installation and Use
manual.
5. Take RTM-ATCA-7350 out of the antistatic package.
6. Fully open the upper and lower ejector handles of the RTM.
7. Align the upper and lower sides of RTM-ATCA-7350 with the guide rails (the edges
of the slot). Slide RTM-ATCA-7350 along the guide rails until the positioning pins of
RTM-ATCA-7350 are inserted in the positioning holes in the shelf.
8. Make sure that the ejector handles are fastened to the beam. Close the upper and
lower ejector handles inwards until the inner sides of the ejector handles are
attached to the face plate.
9. Use the screwdriver to fasten the captive screws clockwise to fix RTM-ATCA-7350.
The LEDs of the RTM are off now.
Figure 2-5 Installing RTM-ATCA-7350
