GE Daughter Card Hardware Preparation and Installation
RTM-ATCA-7350 Installation and Use (6806800H30F)
27
3. As shown in step 1 of the figure below, insert two plastic supports vertically in the
holes used to fasten the GE daughter card.
4. As shown in step 2 of the figure below, at the back side of RTM-ATCA-7350, use a
screwdriver to clockwise fasten the two screws used to fix the plastic supports.
5. Take the GE daughter card out of the antistatic package.
6. Insert the GE daughter card in RTM-ATCA-7350 by facing the daughter card at an
angle of 45° to the RTM. Align the daughter card connector with the connector on
RTM-ATCA-7350, and the daughter card positioning holes with the plastic supports
on RTM-ATCA-7350. Exert even power downwards until the daughter card
connector is fully inserted into the connector on RTM-ATCA-7350 and the daughter
card is fastened by the plastic latches. See step 3 in the figure below.
7. Insert
RTM-ATCA-7350 with the GE daughter card installed in the shelf. For more
information refer, Installing RTM-ATCA-7350 on page 30.
Figure 2-4 Installing the GE Daughter Card
