A SERVICE OF

logo

7
5. Connect the drive bay power cable to the power cable inside the case (Pic A). Connect the drive bay
SATA cable to the SATA slot on the motherboard (Pic B).
6. Insert the 2.5-inch external enclosure (Pic A) into the 3.5-inch drive bay until they are firmly connected.
The eject button on the 3.5-inch drive bay will pop out when the 2.5-inch external enclosure is fully
inserted (Pic B).
7. Turn on the computer power; when the system starts up, the operating system should recognize a new
disk drive. If the system does not recognize the drive, contact technical support at
www.crucial.com/support.
NOTE: The SATA drive is hot-swappable if the motherboard supports this feature; otherwise, the connection
must be made when the power is off. Check with your motherboard or system manufacturer for more
information.
A B
A B