A SERVICE OF

logo

Open as PDF
next previous
4
2. Align the SATA connector on the rear of the SSD with the SATA connector on the rear of the PCB (Pic A),
and then slide the SSD connector onto the PCB connector (Pic B).
3. Hold the PCB and SSD together and flip them
upside down. On the bottom of the PCB,
use the smaller screws to attach the SSD to
the PCB, and then flip the assembled PCB/SSD
unit upright.
4. Align the assembled PCB/SSD unit with
the rounded grooves on both sides of
the external enclosure, and then push
the unit inside the external enclosure.
5. Re-attach the back cover and secure it
with the screws that you removed in step 1.
A B