3-14
Catalyst 6500 Series Switch Content Switching Module with SSL Command Reference
OL-7029-01
Chapter 3 Commands Specific to the Content Switching Module with SSL
crypto ca import pkcs12
crypto ca import pkcs12
To import a PKCS12 file to the Content Switching Module with SSL, use the crypto ca import
command.
crypto ca import trustpoint_label pkcs12 file_system [pkcs12_filename] pass_phrase
Syntax Description
Defaults This command has no default settings.
Command Modes Global configuration
Command History
Command Modes If you are using SSH, we recommend using SCP (secure file transfer) when importing a PKCS12 file.
SCP authenticates the host and encrypts the transfer session.
If you do not specify pkcs12_filename, you will be prompted to accept the default filename (the default
filename is the trustpoint_label) or to enter the filename. For the ftp: or tftp: value, include the full path
in the pkcs12_filename.
You will receive an error if you enter the pass phrase incorrectly.
If there is more than one level of CA, the root CA and all the subordinate CA certificates are exported
in the PKCS12 file.
trustpoint_label Specifies the trustpoint label.
file_system Specifies the file system. Valid values are as follows:
• ftp:—Imports from the FTP: file system
• nvram:—Imports from the NVRAM: file system
• rcp:—Imports from the RCP: file system
• scp:—Imports from the SCP: file system
• tftp:—Imports from the TFTP: file system
pkcs12_filename (Optional) Specifies the name of the PKCS12 file to import.
pass_phrase Specifies the pass phrase of the PKCS12 file.
Release Modification
Cisco IOS Release
12.1(13)E and
SSL Services Module
Release 1.1(1)
Support for this command was introduced on the Catalyst 6500 series
switches.
CSM-S release 1.1(1) This command was introduced.
