CHAPTER 4: BASIC OPERATIONS
33
To broadcast to selected servers:
1. From the Broadcast dialog box, select the mouse and/or keyboard checkboxes
for the servers that are to receive the broadcast commands.
-or-
Press the
Up or Down Arrow keys to move the cursor to the target server. Then
press
Alt+K to select the keyboard checkbox and/or Alt+M to select the mouse
checkbox. Repeat for additional servers.
2. Click OK to save the settings and return to the Setup dialog box. Click X or
press
Escape to return to the Main dialog box.
3. Click Commands. The Commands dialog box appears.
4. Click the Broadcast Enable checkbox to activate broadcasting. The Broadcast
Enable Confi rm/Deny dialog box appears.
Figure 4-17. Broadcast Enable Confirm/Deny Dialog Box
5. Click OK to enable the broadcast. Click X or press Escape to cancel and return
to the Commands dialog box.
6. If broadcasting is enabled, type the information and/or perform the mouse
movements you want to broadcast from the user station. Only servers in the list
are accessible.
NOTE:
The other user is disabled when broadcast mode is enabled.
To turn broadcasting off:
From the Commands dialog box, clear the Broadcast Enable checkbox.
4.7 Changing Your Switch Mode
Your ServSelect II allows you to connect to attached servers using two methods:
Preemptive and Cooperative.
