A SERVICE OF

logo

Network Navigation Tree
primary_dns=
secondary_dns=
enable_ipv6=
get_dns_from_dhcpv6=
get_domain_from_dhcpv6=
enable_ipv4_multiple_routing_tables=
Network/IPv4 and IPv6
IPv4 addresses are always enabled. An administrator can also enable IPv6 addresses at the
appliance_settings/network/ipv6 level. A procedure to enable IPv6 is used as an example in
CLI Equivalent Actions to Web Manager Checkbox Selection on page 19.
IPv4 and IPv6 Navigation Tree
ipv4_static_routes
default_3
gateway=
interface=
metric=
ipv6_static_routes
Table 4.7: Network/IPv4 and IPv6 Options
Network/Devices
The procedure to configure a static IP address for the primary Ethernet interface is usually
performed during installation so that administrators have a fixed IP address for access to the
web manager and can finish configuration.
To configure a IPv4 or IPv6 static IP address:
NOTE: Thisprocedure configureseither an IPv4 or IPv6 staticIP addressfor the ETH0 (eth0) or the ETH1 (eth1)
port. You can configure an IPv6 staticIP addressonlyif IPv6 isenabled.
Chapter 4: CLI Overview for Administrators 35