Chapter 2 Installing ReadySystem 1U Options
ReadySystem 1U Users Guide 17
RdySy1U_15a
Power Switch Cable
to ReadyBoard
Power On
Cable to
ReadyBoard
Power In Cable
to ReadyBoard
Enclosure
Fan Cable
DC In Cable to
Regulator Board
+5VDC Regulator
Board
Figure 2-11. Installing Power Cables
Connecting the Remaining Cables
The following procedure describes how to install the remaining cables to the ReadyBoard. Refer also to
the respective ReadyBoard QuickStart Guide for any variations to the board shown in the figures when
connecting the cables to the ReadyBoard. Skip any cable(s) that do not apply to your situation.
NOTE Ampro recommends using the cable routing shown in the figures.
This will help to ensure cables and wiring do not come in contact
with the heatsinks.
1. Reconnect USB2 & USB3 cables to the USB2 & USB3 openings in the I/O panel as shown in
Figure 2-12.
The USB 2 cable is always connected to pins 3 & 5 on the 10-pin connector and USB 3 is always
connected to pins 4 & 6 on the 10-pin connector, regardless of the ReadyBoard model. This 10-pin
connector has odd/even pin arrangement where all odd pins of the connector are on one side, while
all even pins are on the opposite side of the connector.
2. Connect the USB2 & USB3 cable to the USB2 & USB3 (10-pin) connector (J21) on the
respective ReadyBoard. See Figures 2-9, 2-10, and 2-12.
All USB2 & USB3 connectors are located in the same place on the board and share the same 10-
pin header. Refer to the respective ReadyBoard documentation for the pin-1 location.
3. Connect the Audio cable to the Audio In/Out (16-pin) connector on the respective ReadyBoard.
See Figures 2-9, 2-10, and 2-12.
The Audio In/Out (16-pin) connector placement differs slightly on the various ReadyBoards, but
is in the same general area on the board. Refer to the respective ReadyBoard documentation for
any variations and the pin-1 location.
