Zenoah TR2300 Brush Cutter User Manual


 
46
11. Optional blade usage
English
rotate as soon as the engine is started. When
starting the engine, place the product onto the
ground in a flat clear area and hold it firmly in
place so as to ensure that neither the cutting
part nor the throttle come into contact with any
obstacle when the engine starts. (OPT8)
CUTTING METHOD
a) Use the front left side cutting.
b) Guide the blade from your right to left with it tilted
slightly to your left. (OPT9)
c) When mowing a wide area, start working from your
left end to avoid interference of cut grass.
d) The blade may be seized by weeds if the engine
speed is too low, or the blade cuts too deep into
weeds. Adjust the engine speed and cutting depth
according to the condition of object.
If the grass or other object gets caught in the
blade, or if the unit starts to shake or vibrate,
turn off the engine and check the whole unit.
Change the blade if it has been damaged.
Turn off the engine and make sure the blade has
completely stop before checking the blade, and
removing any object got caught in.
OPERATION
1. Check the bolt to fasten the blade and be sure the
bolt has no fault, and no abrasion.
2. Be sure that the blade and the holder have been
fastened according to instruction and the blade turns
smoothly without abnormal noise. (OPT10)
The rotating parts fastened incorrectly may
cause serious accident to the operator.
Make sure that the blade is not bent, warped,
cracked, broken or damaged.
If you find any error to the blade, discard it and
change new one which is certified by RedMax.
WARNING
WARNING
OPT10
OPT9
OPT8