Zenoah TR2300 Brush Cutter User Manual


 
32
every every every
25 50 100
system/compornent procedure before hours hours hours note
use after after after
fuel leaks, fuel spillage wipe out
fuel tank, air filter, fuel filter inspect/clean ✔✔ replace, if necessary
see ADJUSTING replace carburetor
idle adjusting screw
IDLING SPEED (p.28) if necessary
clean and readjust GAP: .025in(0.6~0.7mm)
spark plug
plug gap replace, if necessary
cylinder fins, intake air cooling vent clean
muffler, spark arrester, cylinder exhaust port
clean
throttle lever, ignition switch check operation
replace if
cutting parts
something's wrong
debris guard make sure to attach
gear case grease
screws/nuts/bolts tighten/replace ✔✔not adjusting screws
ENGINE
SHAFT
MAINTENANCE CHART
Maintenance, replacement, or repair of the emission control
device and systems may be performed by any non-road engine
repair establishment or individual.
9. Maintenance
English