Zenoah G455AVS Chainsaw User Manual


 
FUEL
The RedMax engines are lubricated by oil
specially formulated for air-cooled 2-cycle
gasoline engine use. If RedMax oil is not
available, use an anti-oxidant added quality
oil expressly labeled for air-cooled 2-cycle
engine use.
RECOMMENDED MIXING RATIO
GASOLINE 32 : OIL 1
Exhaust emission are controlled by the
fundamental engine parameters and
components (eq., carburation, ignition
timing and port timing) without addition
of any major hardware or the introduction
of an inert material during combustion.
These engines are certified to operate on
un-leaded gasoline.
The fuel is highly flammable. Do not
smoke or bring any flame or sparks near
fuel.
HOW TO MIX FUEL
1. Measure out the quantities of gasoline
and oil to be mixed.
2. Put some of the gasoline into a clean,
approved fuel container.
3. Pour in all of the oil and agitate well.
4. Pour in the rest of gasoline and agitate
again for at least one minute.
5. Put a clear indication on the outside of the
container to avoid mixing up with gasoline
or other containers.
WARNING !
3. Fuel and Chain oil
FOR YOUR ENGINE LIFE, AVOID;
1. FUEL WITH NO OIL(RAW GASOLINE) –
It will cause severe damage to the engine
inner parts very quickly.
2. GASOHOL – It can cause deterioration of
rubber and/or plastic parts and disruption
of engine lubrication.
3. OIL FOR 4-CYCLE ENGINE USE or
WATER COOLED 2-CYCLE ENGINE
USE – It can cause spark plug fouling,
exhaust port blocking, or piston ring
sticking.
CHAIN OIL
Use motor oil SAE 10W-30 all year round, or
SAE 30-40 in summer and SAE 20 in winter.
NOTE:
Do not use waste or regenerated oil that
can cause damage to the oil pump.
5