Filter
Top Products
G3300 / G3300EZ
GB-9
G
B
Do not start the engine while the chain saw
hangs in one hand. The saw chain may touch
your body. This is very dangerous.
6. When engine has ignited, pull the throttle slightly to
return the choke knob to the original position. If the
engine stops, pull the starter again without pulling
out the choke knob.
7. Allow the engine to warm up with the throttle lever
pulled slightly.
Keep clear of the saw chain as it will start
rotatIng upon starting of engine.
■ CHECKING THE OIL SUPPLY
Make sure to set up the bar and the chain
when checking the oil supply.
If not, the rotating parts may be exposed. It is
very dangerous.
After starting the engine, run the chain at medium speed
and see if chain oil is scattered off as shown in the fig-
ure.
The chain oil flow can be changed by inserting a
screwdriver in the hole on bottom of the clutch side.
Adjust according to your work conditions.
■ ADJUSTING THE CARBURETOR
(1)
(2)
(3)
It is very dangerous to run a chainsaw that
mounts broken parts or lacks any parts.
Before starting engine, make sure that all the
parts including bar and chain are installed
properly.
■ STARTING THE ENGINE
1. Fill fuel and chain oil tanks respectively, and tighten
the caps securely.
(1)
(2)
2. Set the switch to “I” position.
(1)
3. Continuously push the priming bulb until fuel comes
in the bulb.
(1)
4. Pull out the choke knob completely to close the
choke.
(1)
(2) (3)
NOTE: When restarting immediately after stopping the engine, you
need not to pull out the choke knob.
5. While holding the saw unit securely on the ground,
pull the starter rope vigorously.
5. Operating the Engine
(1) Fuel
(2) Chain oil
(1) Switch
(1) Priming bulb
(1) Chain oil
(1) L needle
(2) H needle
(3) Idle adjusting screw
(1) Rich
(2) Lean
(3) Chain oil flow adjusting
(1) Choke knob
(2) Close
(3) Open