Filter
Top Products
G3300 / G3300EZ
GB-6
[G3300]
1. Pull the guard towards the front handle to check that
the chain brake is not engaged.
2. Loosen the nut and remove the chain cover.
3. Gear the chain to the sprocket and, while fitting the
saw chain around the guide bar, mount the guide
bar to the power unit. Adjust the position of the chain
tensioner.
Pay attention to the correct direction of the
saw chain.
(2)
(3)
(1)
4. Fit the chain cover to the power unit and fasten the
nut to finger tightness.
5. While holding up the tip of the bar, adjust the chain
tension by turning the tensioner screw until the tie
straps just touch the bottom side of the bar rail.
2. Explanation of Symbols on the Machine
The port to refuel “MIX GASOLINE”
Position: Fuel cap
The port to top up chain oil
Position: Oil cap
Setting the switch to the “O” position,
the engine stops immediately.
Position: Rear-left of the unit
If you pull out the choke knob, you can
set the choke as a cold start mode.
Position: Upper-right of the aircleaner
cover
3. Installing Guide Bar and Saw Chain
A standard saw unit package contains the items as illustrated.
For safe operation and maintenance, symbols are carved in relief on the machine.
According to these indications, please be careful not to make any mistake.
(1) Moving direction
(2) Tensioner nut
(3) Chain cover
(1) Power unit (2) Bar protector
(3) Guide bar (4) Saw chain
(5) Plug wrench
The screw under the “H” stamp is The
High-speed adjustment screw.
The screw under the “L” stamp is The
Slow-speed adjustment screw.
The screw at the left of the “T” stamp is
the Idle adjustment screw.
Position: Left side of the rear handle
Shows the directions that the chain
brake is released (white arrow) and ac-
tivated (black arrow).
Position: Front of the chain cover
If you turn the rod by screwdriver follow
the arrow to the "MAX" position, the chain
oil flow more, and if you turn to the "MIN"
position, less.
Position: Bottom of the power unit
Open the box and install the guide bar and the saw
chain on the power unit as follows:
The saw chain has very sharp edges. Use
thick protective gloves for safety.