Filter
Top Products
G3300 / G3300EZ / G3300E
GB-12
Before cleaning, the inspecting or repairing
the unit, make sure that engine has stopped
and is cool. Disconnect the spark plug to pre-
vent accidental starting.
■ MAINTENANCE AFTER EACH USE
1. Oiling port
Dismount the guide bar and check the oiling port for
clogging.
7. Maintenance
A log lying on the ground
Saw down halfway, then roll the log over and cut from
the opposite side.
A log hanging off the ground
In area A, saw up from the bottom one-third and finish
by sawing down from the top. In area B, saw down from
the top one-third and finish by sawing up from the bot-
tom.
Cutting the limbs of Fallen Tree
First check to which side the limb is bent. Then make
the initial cut from the bent side and finish by sawing
from the opposite side.
Be alert to the springing back of a cut limb.
Pruning of Standing Tree
Cut up from the bottom, finish down from the top.
• Do not use an unstable foothold or ladder.
• Do not overreach.
• Do not cut above shoulder height.
• Always use both your hands to hold the
saw.
2. Guide bar
When the guide bar is dismounted, remove sawdust in
the bar groove and the oiling port.
Grease the nose sprocket from the feeding port on the
tip of the bar.
3. Others
Check for fuel leakage and loose fastenings and dam-
age to major parts, especially handle joints and guide
bar mounting. If any defects are found, make sure to
have them repaired before operating the saw again.
(1) Oiling port
(1)
(1) Oiling port
(2) Grease port
(3) Sprocket