Filter
Top Products
18
9. Maintenance
GUIDE BAR
1. Remove sawdust in the bar groove and the
oiling port. (MA5)
2. Grease the nose sprocket from the feeding port
on the tip of the guide bar. (MA6)
3. Periodically turn over the guide bar when
mounting it to the unit, in order to prevent partial
wear.
This saw is equipped with one of the following
low kickback bar/chain combinations:
RedMax Part Number
Bar Size Guide Bar Saw Chain
14 (inch) G0011 91SG52X
(35cm)
For replacement, use only above bar and chain,
or the following;
OREGON BAR
14 inch S/N DOUBLE GUARD BAR,
Mount code #A041.
OREGON CHAIN
91SG
AIR FILTER
A clogged air filter can reduce the engine
performance. Daily check the filter elements and
tap off attached saw dust. When cleaning, use
warm, soapy water and dry completely before
installing. When the element is broken or shrunk,
replace with a new one. (MA7)
OILING PORT
Dismount the guide bar and check the oiling port
for blocking by sawdust. (MA8)
GENERAL
Inspect the entire unit for fuel leakage, Ioose
fastenings, and damage to major parts, especially
handle joints and guide bar mounting. When
WARNING
MA7
MA8
MA6
MA5