Filter
Top Products
7. Operation
5. While holding the saw unit securely on the
ground, pull the starter rope vigorously. (OP5)
Do not start the engine while hanging the chain
saw with a hand. The saw chain may touch
your body. It's very dangerous.
6. When engine has ignited first, push in the choke
knob and pull the rope again to start the engine.
7. Allow the engine to warm up with the throttle
lever pulled slightly.
■ CHECKING OIL SUPPLY
Make sure to set up the bar and the chain when
checking the oil supply.
If not, the rotating parts may be exposed. It is
very dangerous.
After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown
in the figure. (OP6)
The oil tank should become nearly empty by the
time fuel in the tank is used up. Be sure to refill the
oil tank every time when refueling the saw.
■ STOPPING ENGINE
1. Release the throttle lever and let the engine run
at low speed for a moment.
2. Put the ignition switch to the “O” position. (OP7)
In case of emergency, turn off the switch without
idling the engine.
NOTE
NOTE
WARNING
WARNING
OP6
OP7
OP5
11