Filter
Top Products
English
5. OPERATION
■ STARTING THE ENGINE
Keep the blades clear of
everything around It as they will
start moving upon the engine
starts.
1. [eHT753S] Make sure that the
throttle lever is at idling position.
[eHT603D] Release the throttle
lever and make sure it is fully
back. (F1)
2. [eHT603D] Set the engine switch
to the “I (RUN)” position. (F1)
3. Push the primer pump until
overflown fuel flows out in the
clear tube. (F2)
4. Move the choke lever to the
closed position. (F3)
(1) Throttle lever (7) Stop
(2) Full throttle (8) Primer pump
(3)
Idling (start position)
(9) Clear tube
(4) Stop switch (10) Choke lever
(5) Engine switch (11) Open
(6) Run (12) Close
5. Place the unit on a flat, firm place.
Keep the cutting head clear of
everything around it.
6. While holding the unit firmly, pull
out the starter rope quickly. (F4)
7. After the engine has started, allow
the engine to warm up. Pull the
throttle lever.
■ STOPPING THE ENGINE (F1)
[eHT753S]
1. Please return the throttle lever
completely.
2. Press the stop switch until the
engine comes to a complete stop.
[eHT603D]
1. Release the throttle lever.
2. Move the engine switch to the
“O(STOP)”position.
If the engine doesn’t stop after
stopping the switch, close the choke
so that engine will stop after a little.
NOTE
WARNING
F1
F2
F3
F4
13