Zenoah EBZ3000RH-CA Blower User Manual


 
30
8. Operation
English
STARTING ENGINE
Avoid operating the blower with the flexible tube
and swivel joint disconnected. That will reduce
the cooling air and the engine could be damaged
by overheating.
1. Push the primer bulb until fuel flows out in the clear
tube. (F6)
(1) Primer Bulb
2. When the engine is cool, close the choke. (F7)
(1) Choke Lever
(2) CLOSE
(3) OPEN
3. Set the ignition switch to the start position. (F8)
4. Set the throttle lever in idling position. (F8)
(1) Full Throttle
(2) Idling
(3) Ignition Switch
5. To start, hold the top of the blower firmly and hold
the flame by your foot. Pull the starter knob slowly
until you feel it engage and then give it a vigorous
strong pull. (F9)
Avoid pulling the starter rope out to its full
extent and allowing the starter rope to snap
back. This will prevent premature damage to the
starter.
Do not let a person stand near the blower or the
exhaust port.
Never to touch the muffler, spark plug, other
metallic parts of the engine or engine cover
while the engine is in operation or immediately
after shutting down the engine. These metallic
IMPORTANT
IMPORTANT
F9
(1)
(2)
(3)
F8
F7
F6