Filter
Top Products
GB-13
EB7001
G
B
9. Maintenance
HARNESS
If the harness is damaged it may break during use, thus
causing the product to fall and resulting in personal in-
jury. Follow the instructions below to replace the harness
with new one.
1. Pass the upper end of the harness through the hanger,
marking the FLAPPED SIDE OUTSIDE.
2. Put the end of the harness through the ring on the
harness, and then push the ring toward the hanger
as close as possible.
WARNING
• The flap on the end of the harness works as a stop-
per. Never install the harness with the flapped side
inside, or the unit may fall from the operation,
which could result in injury to the operator and/or
damage to the unit.
• Do not apply liquid type screw lock glue on screws
or bolts used to fix plastics components. Adher-
ence of this type of glue may cause cracks on plas-
tics and end up with the breakage.
(1)Ring
(2)Flapped side
11. Disposal
• When you dispose of the machine, do not disassemble
the machine.
• When disposing your machine, fuel or oil for the ma-
chine, be sure to allow your local regulations.
10. Storage
BEFORE STORING THE BLOWER:
1. Drain a fuel tank and push the primer bulb until it be-
comes empty of fuel.
2. Remove the spark plug and drop a spoonful of 2-cycle
oil into the cylider. Crank the engine several times and
install the spark plug.
3. Store unit in a dry, dust free place, out of the reach of
children.