Filter
Top Products
GB-7
G
B
BCZ4505DW / BCZ4505CL / BCZ5010DL / BCZ5010DW / BCZ5010CL
BEFORE STARTING
THE ENGINE
1.
The area within a perimeter of
15 m (50 ft) of the person using the
product should be considered a haz-
ardous area into which no one should
enter. If necessary, yellow warning
rope, warning signs should be placed
around the perimeter of the area.
When work is to be performed simul-
taneously by two or more persons,
care should also be taken to con-
stantly look around or otherwise
check for the presence and locations
of other people working so as to main-
tain a distance between each person
sufficient to ensure safety.
2.
Check the condition of working area
to avoid any accident by hitting hid-
den obstacles such as stumps,
stones, cans, or broken glass.
IMPORTANT
Remove any obstacle before begin-
ning work.
3. Inspect the entire unit for loose
fasteners and fuel leakage. Make
sure that the cutting attachment
is properly installed and securely
fastened.
4.
Be sure to attach the cutting at-
tachment guard securely in place,
or you may get serious injury.
5. Always use the shoulder strap.
Adjust the harness for comfort be-
fore starting the engine. The har-
ness should be adjusted so the
left hand can comfortably hold the
handlebar grip approximately
waist high.
STARTING THE ENGINE
1. Keep bystanders and animals at
least 15 m (50 ft) away from the
operating point. If you are ap-
proached, immediately stop the
engine.
2.
The product is equipped with a cen-
trifugal clutch mechanism, so the cut-
ting attachment begins to rotate as
soon as the engine is started by put-
ting the throttle trigger into the start
position. When starting the engine,
place the product onto the ground in
a flat clear area and hold it firmly in
place so as to ensure that neither the
cutting attachment nor the throttle
trigger come into contact with any ob-
stacle when the engine starts.
WARNING
Never place the throttle into the
high-speed position when starting
the engine.
3. After starting the engine, check
to make sure that the cutting at-
tachment stops rotating when the
throttle trigger is moved fully back
to its original position. If it contin-
ues to rotate even after the throttle
trigger has been moved fully
back, turn off the engine and take
the unit to your authorized
ZENOAH servicing dealer for re-
pair.
USING THE PRODUCT
IMPORTANT
Cut only materials recommended by
the manufacturer. And use only for
tasks explained in the manual.
1. Grip the handles firmly with both
hands using your whole hand.
Place your feet slightly apart
(slightly further apart than the
width of your shoulders) so that
your weight is distributed evenly
across both legs, and always be
sure to maintain a steady, even
posture while working.
2. Keep cutting attachment below
waist level.
3. Maintain the speed of the engine
at the level required to perform
cutting work, and never raise the
speed of the engine above the
level necessary.
4. If the unit starts to shake or vi-
brate, turn off the engine and
check the whole unit. Do not use
it until the trouble has been prop-
erly corrected.
5. Keep all parts of your body away
from rotating cutting attachment
and hot surfaces.
6. Never touch the muffler, spark
plug, or other metallic parts of the
engine while the engine is in op-
eration or immediately after shut-
ting down the engine. Doing so
could result in serious burns or
electrical shock.
5. For safe operation