Filter
Top Products
12
ASSEMBLY
Your new mower has been assembled at the factory with the exception of those parts left un-
assembled for shipping purposes. To ensure safe and proper operation of your mower, all
parts and hardware you assemble must be tightened securely. Use the correct tools as
necessary to insure proper tightness.
TOOLS REQUIRED
FOR ASSEMBLY
1. 9/16" wrench or 9/16" socket w/ drive
ratchet
2. Tire pressure gauge
3. Nail bar or claw hammer
4. Wire snips
When right or left hand is mentioned in this
manual, it means when you are in the operating
position (seated).
TO REMOVE THE MOWER
FROM CRATE
UNPACK CRATE
• Using the nail bar or hammer, remove the
top of the crate first. Then remove the
sides of the crate and place these out of
the way. Be careful of any exposed nails
or staples.
• Remove the plastic bag that covers the
mower.
• Using the wire snips, cut any plastic ties
that are holding the mower to the crate.
• Remove the seat off of the front of the
mower and place in a safe location.
BEFORE REMOVING THE
MOWER FROM THE SKID
ATTACH SEAT (See Fig. 1)
The seat position should be adjusted forward or
backward so that the operator can comfortably
reach the deck lift pedal and safely operate the
mower. See "Service and Adjustment" Section
of this manual.
• Remove protective wrap from the seat.
• Remove the three prong knobs and
washers from the seat and place in the
storage area in the right side console.
• Raise the seat pan up so that the bottom
can be easily accessed.
• Securing one of the three prong knobs
and washers, insert it thru the seat pan
slot and into the corresponding threaded
hole in the seat bottom.
• Repeat for the other three holes.
• Tighten the three prong knobs in the
approximate position desired for the
seat.
• Connect the wiring harness to the seat
switch.
Adjustments may be required to position the
seat in the desired position. Refer to the
"Service and Adjustment" section of this
manual.
FIGURE 1
ATTACH CONTROL LEVERS (See Fig. 2)
• Using the 9/16" wrench or socket and
ratchet, remove the bottom hex bolt and
spring washer from the control arm.
• Rotate the control lever up until the bolt
and spring washer can be placed thru
the slot in the bottom of the control lever
and threaded back into the control arm.
• Center the hex bolt in the slot on the
control lever. Using the wrench or
ratchet, tighten both the top and bottom
hex bolts.
• Repeat on opposite side of the mower.
KNOBS
WIRE
HARNESS
SEAT PAN
CZ-1