Filter
Top Products
4
OPERATING INSTRUCTIONS
Figure 2 Figure 4
BEFORE OPERATING:
Be thoroughly familiar with all controls and how to use them
before operating the Dethatcher/Slicer. Make the following
checks and perform the service as required before each start
up.
PRE-START CHECK LIST
CHECK ENGINE OIL and bring level up to full. (Refer to
engine manual for oil specifications).
CHECK AIR CLEANER and service according to instructions
in Engine Manual.
FILL FUEL TANK where fumes will be safely dissipated.
Refer to Engine Manual for fuel specifications.
CHECK DETHATCHER OR SLICER SHAFT ASSEMBLY to
make sure it is free of dirt and other debris.
CHECK EXTERNAL SURFACES and remove any dirt and
dust accumulation.
CHECK GUARDS to make sure all are in proper position and
securely tightened.
STARTING-STOPPING
Know beforehand how to stop the engine and rotation
of the DETHATCHER or SLICER shaft in preparation for
possible emergencies.
The engine of the DETHATCHER/SLICER is stopped by
pulling the engine THROTTLE CONTROL to the rear to
“STOP”. See Figure 2
Figure 3
Shaft rotation is stopped by releasing the CLUTCH CONTROL
BAIL. See Figure 3.
OPERATE ENGINE AS FOLLOWS:
STEP 1:
Move HEIGHT ADJUSTMENT LEVER to “TRANSPORT”
position. (This insures that the Shaft Assembly is clear of the
ground/pavement should accidental engagement of CLUTCH
CONTROL BAIL occur.) See Figure 4.