Filter
Top Products
13
Motor type ...............................................................................................................................................................A.C.,120 Volts Electric
Operating RPM.............................................................................................................................................................. up to 14,000 rpm
Ignition Switch...................................................................................................................................................... Bail Lock Safety Button
Amperage.................................................................................................................................................................................... 8.5 amps
Overload Protection.................................................................................................................................................120V, 15 amp Breaker
Handles .................................................................................................................................................................................... Steel Tube
Approximate Unit Weight ..................................................................................................................................................... 20 lbs. (9 kg.)
Snow Depth (maximum)........................................................................................................................................ 6 inches (0.152 meters)
Cleared Path Width............................................................................................................................................. 12 inches (0.318 meters)
*All specifications are based on the latest product information available at the time of printing. We reserve the right to make changes
at any time without notice.
If further assistance is required, contact your authorized service dealer
C A U S E A C T I O N
Belt is damaged Replace the belt, according to Inspecting/Replacing the
Driver Belt
C A U S E A C T I O N
Unit is unplugged Check cord to make sure it is plugged into an electrical outlet
Starter button or bail were improperly used Press in starter button, hold it, and hold bail
Overload protection switch has popped out Push it in and follow the Starting Instructions
MOTOR*
DRIVE SHAFT ASSEMBLY AND SNOW THROWER UNIT*
C A U S E A C T I O N
Scraper is worn Replace the scraper
SPECIFICATIONS
TROUBLESHOOTING
UNIT LEAVES A THIN LAYER OF SNOW ON PLOWED SURFACES
MOTOR IS ON, BUT ROTOR WILL NOT TURN
UNIT WILL NOT START