Filter
Top Products
12
NEUTRAL ADJUSTMENT TEST
To perform the NEUTRAL ADJUSTMENT TEST answer the following questions.
• With the drive clutch control released, push mower forward and pull it backward. Does it move freely?
• Squeeze the drive clutch control and pull the mower backward. Do the rear wheels lock (not turn)?
• Is the drive clutch control cable free of kinks or sharp bends?
If you answered “yes” to all three questions, your mower passed the test and you can start your mower. If you
answered “no” to any of the three questions, you will have to adjust the drive clutch control following instructions
in the DRIVE CLUTCH CONTROL ADJUSTMENT section.
TO START ENGINE AND ENGAGE BLADE
• Move the throttle control on the engine to the fast (rabbit) position.
• Prime engine as instructed in the separate engine manual.
• Stand behind the unit, squeeze the blade control handle and hold it against the upper handle.
NOTE: If any problems are encountered, refer to the TROUBLE SHOOTING Section of this manual.
TO STOP ENGINE AND BLADE
• Release the blade control handle to stop the engine and the blade.
WARNING: The blade continues to rotate for a few seconds after the engine is shut off.
USING YOUR ROTARY MOWER
Be sure that the lawn is clear of stones, sticks, wire, or other objects which could damage the lawn mower or the
engine. Such objects could be accidently thrown by the mower in any direction and cause serious personal injury
to the operator and others.
For best results, do not cut wet grass because it tends to stick to the underside of the mower, preventing proper
discharge of grass clippings, and could cause you to slip and fall. New grass, thick grass or wet grass may require
a narrower cut.
For a healthier lawn, never cut off more than one-third of the total length of the grass. Your lawn should be cut in
the fall as long as there is growth.
This mower is designed to be operated at full throttle to give you the best cut and do the most effective job of
mowing or mulching.
WARNING: If you strike a foreign object, stop the engine. Remove wire from the spark plug,
thoroughly inspect the mower for any damage, and repair the damage before restarting and operating
the mower. Extensive vibration of the mower during operation is an indication of damage. The unit
should be promptly inspected and repaired.