Filter
Top Products
10
SECTION 7: CONTROLS
Figure 5
BLADE CONTROL HANDLE
The blade control handle is located on the upper handle of the mower. See Figure 5. The blade control handle
must be depressed in order to start and operate the unit. Release the blade control handle to stop the engine and
blade.
WARNING: The blade control handle is a safety device. Never attempt to bypass its operations. The
blade will be rotating whenever the engine is running.
THROTTLE CONTROL
The throttle is located on the engine. It is used to regulate the engine speed.
WARNING: The throttle control cannot be used to stop the engine. Do not adjust the throttle
control with the engine running.
RECOIL STARTER
The recoil starter handle is attached to the lower handle. See Figure 5. Stand behind the unit in the operating
position to start the unit.
DRIVE CLUTCH CONTROL
Squeeze the drive clutch control to engage the drive system. Release the clutch control to disengage the drive
system. Release the clutch control to slow down when negotiating an obstacle, making a turn or stopping.
SHIFT LEVER
The shift lever is located on the drive clutch control housing on the upper handle. See Figure 5. This lever is used
to select the forward speed of the mower. When changing speed selection, release the drive clutch control.
NOTE: Move the shift lever only when the engine is running. Changing the shift lever setting with the engine off
can cause damage to the mower.
Recoil Starter
Blade Control Handle
Throttle Control
Cutting Height
Adjustment Lever
Shift Lever
Drive
Clutch
Control