Filter
Top Products
7
SECTION 3: UNPACKING & ASSEMBLING YOUR RIDER MOWER
• Remove all screws and staples from crate.
• Holding the sides of the crate firmly, lift the top part
of the crate up and keep it aside. Avoid tire
punctures.
• Remove and discard plastic bag covering unit.
• Lift the rear of the mower and clear the bottom of
the crate. Repeat for the front.
• Be sure parking brake is disengaged; roll unit out of
the crate’s way.
Loose Parts
• Remove loose parts from the grass catcher and/or
the crate very carefully. Refer to Figure 1.
1. Mulching plug & side-discharge chute
2. Oil drain sleeve
3. Operator’s manual (not shown)
4. Ignition keys (not shown)
Figure 1
Attaching Battery Cables
The battery is located under the hood assembly above
the left rear wheel. Refer to Figure 3 .
• To access the battery, lift the hood assembly from
the left side of the seat only. Stand on the right side
of the unit and pivot the hood assembly towards
you until fully opened. See Figure 2 .
CAUTION: Do not lift the hood assembly by the two
vent openings located behind the seat.
Figure 2
• Remove both wing nuts securing the battery and
cover to the battery hold-down rods. See Figure 3 .
• Remove red and black insulation caps from battery
terminals.
• Remove battery terminal screws with a Phillips
screw driver or a 10 mm. socket wrench.
• Attach the red battery cable to the positive terminal
(marked +), and the black battery cable to the
negative terminal (marked -) on the battery. See
Figure 3 .
• Align the cables with the slots in the battery cover
and tighten the screws on the battery terminals.
WARNING: Press the battery cables
against side of battery so that these do not
make contact with flange of rider frame
when it is opened or closed.
• Reassemble the battery cover to the hold-down
rods on two ends with the two wing nuts removed
earlier. Check to ensure that the cables pass easily
through slots in cover.
• Place your right hand on the left side of the seat
and slowly lower the hood assembly until it is fully
closed.
CAUTION: Do not place your hand around the bottom
edge of the hood assembly; it may get pinched between
the hood assembly and grass catcher or the frame rail.
Figure 3
Attaching Side-Discharge Chute
Your riding mower is shipped to you with the grass
catcher fully assembled on the unit. A side-discharge
chute and a mulching plug are included as loose parts.
Follow the instructions below to attach the side-
discharge chute.
Side-Discharge
Chute
Mulching
Plug
Oil Drain
Sleeve
Vent
Opening
Hood Assembly
Battery
Cable
Battery
Rider
Frame
Wing
Positive
Wing
Nut
Negative
Terminal
Cover
Nut
Terminal