Filter
Top Products
6
On/Off Switch
The On/Off switch is located on the upper handle. The
switch must be in the On (I) to start engine and Off (O)
to stop engine.
Handle Connectors
The handle connectors are on each side between lower
and upper handle. They are used to lock the upper
handle in a set position.
Front Handle
The front handle is used as support when grasping the
starter handle during starting.
Tines
The tines are used to cultivate, furrow, and prepare
your garden for seeding.
Wheel Support Bracket
The wheel support bracket is attached to the tailpiece
bracket behind the cultivator. It is used to adjust the
wheels to a higher or lower resting position.
Edger Wheel and Blade
The edger wheel and blade are separate parts that do
not come attached on the cultivator. The are to be used
instead of the cultivator tines for vertical edging.
Stopping Engine
• Push the On/Off switch to Off (O) position to stop
engine and tines.
• Disconnect spark plug wire from spark plug and
ground against the engine.
Figure 2
SECTION 4: OPERATING YOUR CULTIVATOR
Oil Fill-Up
Using the proper type and weight of oil in the crankcase
is extremely important. Check the oil before each use
and change the oil regularly. Failure to use the correct
oil or using dirty oil can cause premature engine wear
and failure.
Use a high-quality SAE 30 weight oil of API (American
Petroleum Institute) service class SF, SG, or SH.
NOTE: This unit is shipped without oil in the engine. In
order to avoid damage to the unit, put the
recommended oil in the crankcase before attempting to
start unit.
This unit is shipped with one 3.4 fluid oz. (100ml) bottle
of SAE 30 SF, SG, or SH oil.
NOTE: This cultivator is shipped for operation in
conditions above 40°F (4°C). For cold weather
operation, temperatures below 40°F (4°C) use a high-
quality SAE 10W30 weight oil of API (American
Petroleum Institute) service class SF, SG, or SH.
• Lay the cultivator back in a horizontal position on a
flat level surface with the upper handle touching the
ground.
Throttle Lever
On/Off Switch
Handle
Connectors
Primer
Starter Handle
Front Handle
Cultivator
Choke Lever
Edger Wheel
Edger Blade
Tines