Yard Machines 140 Snow Blower User Manual


 
14
SECTION 10: OFF-SEASON STORAGE
WARNING:
Never store engine with fuel in tank indoors or in enclosed, poorly ventilated
areas where fuel fumes may reach an open flame, spark or pilot light as on a furnace, water
heater, clothes dryer, or other gas appliance.
Clean snow thrower thoroughly.
Follow “Storage” instructions found in the separate Engine Operator’s Manual. Preparing the engine for
storage properly is important to prevent problems next season.
Store in a clean, dry area. Block the snow thrower up so it is not resting on the rubber auger blades.
NOTE:
When storing any type of power equipment in an poorly ventilated or metal storage shed, care should
be taken to rustproof the equipment, especially springs, cables and all moving parts.
SECTION 11: TROUBLE SHOOTING GUIDE
Refer to separate engine manual packed with your mower for more engine related information.
NOTE:
For repairs beyond the minor adjustments listed above, contact your nearest authorized service dealer
or call 1-800-800-7310 for the Customer Support Center.
Trouble Possible Cause(s) Corrective Action
Engine fails to start Fuel tank empty, or stale fuel.
Blocked fuel line.
Key not in switch on engine.
Spark plug wire disconnected.
Faulty spark plug.
Improper gasoline and oil mixture.
Fill tank with clean, fresh gasoline/oil mixture. Refer to
engine manual packed with your unit.
Clean fuel line.
Insert Key
Connect wire to spark plug.
Clean, adjust gap or replace.
Refer to fuel mixture in separate engine manual.
Engine runs erratic Unit running on CHOKE.
Blocked fuel line or stale fuel.
Water or dirt in fuel system.
Carburetor out of adjustment.
Move choke lever to OFF position.
Clean fuel line; fill tank with clean, fresh gasoline/oil.
Drain fuel tank. Refill with clean, fresh gasoline/oil.
Refer to engine manual packed with your unit
Refer to engine manual packed with your unit or have
carburetor adjusted by an authorized service dealer
Engine overheats Incorrect fuel mixture.
Carburetor not adjusted properly.
Drain fuel tank. Refill with proper fuel mixture. Refer to
engine manual packed with your unit.
Refer to engine manual packed with your unit or have
carburetor adjusted by an authorized service dealer.
Loss of power Spark plug wire loose.
Vent in gas cap plugged.
Exhaust port plugged.
Connect and tighten spark plug wire.
Clear vent.
Clean-see maintenance section.
Excessive vibration Loose parts or damaged auger. Stop engine immediately and disconnect spark plug
wire. Tighten all bolts and nuts. Make all necessary
repairs. If vibration continues, have unit serviced by an
authorized service dealer.
Unit fails to propel itself. Incorrect adjustment of drive cable
Drive belt loose or damaged.
Adjust drive cable. Refer to Adjustment section of this
manual.
Replace drive belt. Refer To Belt Replacement in
Maintenance section of this manual.
Unit fails to discharge snow. Discharge chute clogged.
Foreign object lodged in auger.
Incorrect adjustment of drive cable.
Drive belt loose or damage.
Stop engine immediately and disconnect spark plug
wire. Clean discharge chute and inside of auger housing
Stop engine immediately and disconnect spark plug
wire. Remove object from auger.
Adjust drive cable. Refer to Belt Tension Adjustment in
Adjustment section of this manual.
Replace drive belt. Refer to Belt Replacement in
Maintenance section of this manual.