Filter
Top Products
AE01100
Battery Charging
NOTE:
The generator DC rated voltage is 12V.
1. Wind the battery charging lead 2 or 3 turns around
the handle and plug into DC receptacle.
NOTE:
9 Make connections to the battery after starting the
engine.
9 Clamp the red wire to the positive (+) terminal and
the black wire to the negative (-) terminal of the
battery. Do not reverse these positions.
1 Red
2 Black
2. Start the engine.
3. Press in the DC protector and install the battery.
cC
9 Be sure the economy control switch is turned
off while charging the battery.
9 Be sure the battery leads are properly con-
nected.
9 Be sure the breather hose is properly connect-
ed and is not damaged or obstructed.
9 Reduce the load to the specified generator
rated output if the DC protector turns off. If it
turns off again, consult a Yamaha dealer.
NOTE:
Press to reset the DC protector.
1 “RESET”
2 “OFF”
NOTE:
9 At full charge, electrolyte specific gravity is
between 1.26 and 1.28.
9 Check specific gravity hourly.
– 17 –
761-079a
762-040
1
2
6v 6v
12v
762-041
763-238a
q
w
7CG-28199-10 4/1/04 3:13 PM Page 17