Filter
Top Products
AE01099
DC PROTECTOR
The DC protector turns off automatically when the load
exceeds the generator rated output.
cC
Reduce the load to the specified generator rated
output if the DC protector turns off. If it turns off
again, consult a Yamaha dealer.
NOTE:
Press to reset the DC protector.
1 “RESET”
2 “OFF”
– 9 –
763-224a
763-238a
q
w
707-096
w
q
AE01021
FUEL TANK CAP AIR VENT KNOB
The fuel tank cap is provided with an air vent knob to
stop fuel flow.
The air vent knob must be turned 1 turn counterclock-
wise from the tightened position. This will allow fuel to
flow to the carburetor and the engine to run.
When the engine is not in use, tighten the air vent
knob clockwise until it is finger-tight to stop fuel flow.
1 Air vent knob
2 Fuel tank cap
763-227
q
707-098
OFF
ON
AE01034
FUEL COCK KNOB
The fuel cock knob is used to supply fuel from the fuel
tank to the carburetor.
Remove the cover 1 and the fuel cock lever can be
found inside. If for some reason the fuel cock knob
cannot be turned, this lever can be used to supply fuel.
7CG-28199-10 4/1/04 3:13 PM Page 9