Xantrex Technology 1200, 1750 Portable Generator User Manual


 
Installing the XPower Plus
3–15
Materials
The following checklist is a general list of required materials. Optional
components are indicated by an *.
Four corrosion-resistant fasteners sized #10 or larger for mounting the
inverter
Copper DC input cable as calculated in
Table 3-1 on page 3–7 for the XPower 1200 Plus
Table 3-3 on page 3–10 for the XPower 1750 Plus
Two 5/16 inch ring terminals sized for the cable diameter (or box-lug
terminals) to connect the DC cables to the DC cabling terminal
Lugs and terminals to connect the DC cables that connect to the battery
and fuse holder(s)
DC fuse(s) as calculated in “Calculating Fuse/Circuit Breaker Size” on
page 3–12 and fuse holder(s)
Copper chassis ground cable as calculated in
Table 3-2 on page 3–8 for the XPower 1200 Plus
Table 3-4 on page 3–11 for the XPower 1750 Plus
Ring terminal (appropriately sized to connect copper cable to chassis
ground screw) that meets the following specifications:
•#10 stud
UL/CSA approved
copper
tin-plated
Battery isolator (if connecting to a multiple-battery system)
Battery selector switch*
Alternator controller*
High-output alternator*
* Consult Appendix B “Battery Types and Sizes” and Appendix C
“Alternators and Charging Systems” to determine whether you need these
components.