Filter
Top Products
15
Ratings
The Appliance Module can be used to control an incandescent lamp rated up to 500W.
It can also control other types of lamps such as fluorescent or energy saving lamps, low
voltage lamps, or lamps that include a dimmer control. And of course it can be used to
control appliances. Caution: Observe the ratings on the label on the back of the
Appliance Module.
Setting The Appliance Module’s
Code (modules sold separately)
Using a small screwdriver, set the red House
Code dial to the same letter as your Mini
Timer. Set the Black Unit Code dial to any
unused number.
3. Plug the Module into
the same wall outlet
as your controller (see
testing below).
2. Plug an appliance
into the Module.
1. Set the House
Code and Unit
Code.
Testing The Appliance Module
Make sure the appliance’s switch is on. Plug the Module into the same wall outlet as
your Mini Timer, press the ON and OFF buttons on the Mini Timer that correspond to
the Unit Code setting on the Module. If the Module turns On and Off you can unplug
the Module or Mini Timer and move it to its permanent location. If you can’t control the
module, contact www.x10.com/support for help.
Setting up the Appliance Module
UNIT CODE
DIAL
HOUSE CODE
DIAL