Filter
Top Products
1312
1312
2-in-1 Cordless Li-ion Grass Trimmer/Edger EN
this is quit normal. After about 5 seconds the
line will be cut to the correct length and the
noise will reduce as the motor receives full
speed.
If the noise of the line being cut can’t be heard,
more line will need to be fed out.
To feed more line, it is first necessary to allow
the trimmer to stop completely, then restart,
allowing the motor to reach full speed.
Repeat above until you hear the lines hitting
against the line cutter. (Do not repeat this
procedure more than 6 times)
TO MANUALLY FEED THE LINE (See Fig
M1)
If required, line can be feed out manually
To operate, press and release manual line feed
button (16), while gently pulling out the line
until it is long enough to reach the line cutter.
If the line extends past the line cutter, too
much line has been fed out.
If too much line is fed out, remove the spool
cap and turn spool counter-clockwise until the
line is at the desired length.
TO REMOVE THE CAP (See Fig M2)
Press and hold in the two latches (12).
Pull cap away from the spool holder
When refitting the spool cap.
Keep all areas of the cap and spool holder
clean.
Replace the cap, pressing firmly down towards
the spool holder to ensure cap is fully located
into position.
Check that the cap is correctly fitted by trying
to remove it without depressing the two
latches.
TO REPLACE CUT LINE.
For your convenience it is recommended you
buy spool and line assembly.
To fit spool and line assembly:
Remove old spool.
Place new spool into cap with cut out areas
of the spool in line with eyelet.
Release line from cleat and feed line through
eyelet.
Refit the cap.
To fit nylon line only:
WARNING! Take approximately 15ft
(4.5m) of line. Insert 5/8”(15mm )of
line into the spool holes and wind line in the
direction of the arrows on the top of the spool.
Your Trimmer is designed to use only line
with a maximum diameter of 0.065” /
1.65mm.
IMPORTANT: Leave approximately 4”
(100mm) of line unwound and place into cleat.
Care should be taken to ensure that the line is
neatly coiled on the spool. Failure to do so will
impair the efficiency of the automatic line feed.
Then fit spool as described in “To fit spool
and line complete”.
STORING YOUR GRASS
TRIMMER
A) ASSEMBLY OF THE WALL MOUNT
BRACKETS (See Fig N)
Attach the wall-mount bracket to the wall with
the screws provided.
Tighten all the screws securely. Carefully check
the bracket after mounting to make sure that
no movement can occur during use.
WARNING: Always make sure your
wall-mount bracket is securely mounted
to the wall. Failure to do so could result in an
accident, resulting in possible serious personal
injury.
B) STORING YOUR GRASS TRIMMER
(See Fig O)
Adjust the auxiliary handle position close to
the main handle and lower it into the bracket,
now the grass trimmer can be stored into the
wall mount bracket as illustrated.
Store in a dry place where your trimmer can
be protected from damage.
MAINTENANCE
After use, disconnect the battery from the
mains and check for damage.
Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never
use water or chemical cleaners to clean your