Filter
Top Products
16 Assembly
MAN0101 (Rev.10/15/2004)
Figure 14. Idler Bracket Assembly Installed
Install Roller Chains
1. Place roller chain (A - 35 link) around the seed box
sprocket and the large inner sprocket on the idler
bracket assembly. Secure chain using master link.
2. Install roller chain (B - 28 link) around the rear drive
sprocket and smaller outer sprocket on the idler
bracket assembly. Secure chain using master link.
3. Align the seed box sprocket and large inner
sprocket on the idler bracket by adjusting seed box
side to side.
4. Tighten hardware securing seed box to renovator
frame.
5. Slide idler bracket assembly forward to apply
tension to the horizontal drive chain.
6. Slide idler and spring bracket down to apply
tension to the vertical drive chain.
NOTE: Do not over tighten. Allow some slack in chain.
7. Adjust opposite side of roller to level.
A. Roller chain 35-LK w/adjustable links
B. Roller chain 28-LK w/adjustable links
Figure 15. Sprockets and Chains Installed
DP14
Idler Bracket
Assembly
3130
3130
DP13
A
B
Idler Bracket
Assembly