Filter
Top Products
Operation 15
MAN0556 (9/21/2007)
and load is stable.
• Be extra careful when operating on a slope.
• Do not operate on steep slopes.
• Do not stop, start or change directions sud-
denly on slopes.
• If loader is equipped with round bale attach-
ments, always approach bale with tractor facing
uphill.
• Be sure tractor tire spacing and rear ballast is
correct before using loader.
• Tractor must be equipped with a Roll-Over
Protective Structure (ROPS) and seat belt. Keep
seat belt securely fastened and keep foldable
ROPS systems in “locked up” position at all
times.
Use extreme care when operating the loader on a
slope, keeping the bucket as low as possible. This will
maintain a low center of gravity for the bucket and trac-
tor and will provide maximum tractor stability.
When transporting the load, keep the bucket as low as
possible to avoid tipping in case a wheel drops in a rut.
Figure 9. Operating on a Slope
Dumping Bucket
Figure 10. Dumping Bucket
Lift the bucket high enough to clear the side of the vehi-
cle. Move the tractor in as close as possible, then
dump the bucket. See Figure 10.
Lowering Bucket
After the bucket is dumped, back away from the vehicle
while lowering and rolling back the bucket.
Figure 11. Control Handle Function
Operating with Float Control
During hard surface operation, keep the bucket level
and put the lift control in the float position to permit the
bucket to float on the working surface. If hydraulic
down pressure is exerted on the bucket, it will wear
faster than normal.
The float will also prevent the mixing of surface mate-
rial with stockpile material. The float position will
reduce the chance of surface gouging when removing
snow or other material.
Figure 12. Float Position
Loading from a Bank
See Figure 13.
Exercise caution when undercutting high banks. Dirt
slides can be dangerous. Load the bucket from as low
a position as possible for maximum efficiency. Loader
lift and break-away capacity diminish as loading height
is increased.
Keep the bucket level when approaching a bank or
pile. This will help prevent gouging in the work area.