Filter
Top Products
26 Assembly
MAN0875 (2/8/2011)
ASSEMBLY
DEALER SET-UP INSTRUCTIONS
Assembly of this Mow’n Machine is the responsibility of
the Woods dealer. It should be delivered to the owner
completely assembled, lubricated, and adjusted for
normal cutting conditions.
Set up the Mow’n Machine as received from the factory
with these instructions. Complete the Dealer Check
Lists on page 28 when assembly is completed.
Power Unit Preparation
1. Remove crating from around power unit. Remove
power unit from pallet and place on blocks.
2. Remove Operator’s Manual from power unit frame
and save for original retail purchaser.
NOTE: Dealer must complete and return product
registration card at time of sale.
Lubrication
NOTICE
■ Running engine without oil will cause engine
failure.
1. Check engine oil level (30W).
2. Check that oil levels (20W-50) in transmission
reservoir are full.
NOTE: See Owner Service section for engine,
transmission, and lubrication information.
Fuel
Fill fuel tank with the correct fuel. Refer to engine man-
ual.
INSTALL DRIVE TIRES
Figure 19. Drive Tire Installed
1. Install drive tires using five lug bolts (1) from bag of
loose parts shipped with machine.
2. Torque lug bolts to 85 lbs-ft.
Drive Tire Pressure:
Turf Tires 12 psi
Knobby Tires 12 psi
Chevron Tires 10 - 12 psi
ADJUST STEERING HANDLES
Figure 20. Steering Handle Adjustment
The steering handles are shipped loose, inside the foot
rest.
1. Remove whiz bolt (3) and lock nut (4) from left
steering lever mount (2).
2. Position steering handle (1) to desired location on
steering lever mount (2). The top and middle holes
are for taller operators and the middle and bottom
holes are for shorter operators. Do not tighten
hardware at this time. Repeat steps 1 and 2 for
right steering handle.
3. Rotate handles inward. Align handles with one
another. Torque all hardware to 12 lbs-ft. Make
sure handles stay in alignment.
1
DP5
1. Lug Bolt
4
3
1
2
DP8
1. Steering lever
2. Steering lever mount
3. 5/16 NC x 1 Whiz bolt
4. 5/16 Flanged lock nut