Filter
Top Products
Dealer Service 35
MAN0571 (Rev. 6/15/2007)
Crossbar Installation
1. Using emery cloth (220 or finer), remove surface
rust, and foreign material from hub, splined
gearbox vertical shaft, and crossbar. See Figure
19.
Figure 19. Typical Crossbar and Gearbox Shaft
2. Install crossbar (2) on splined shaft. See Figure 20.
Install nut (3). Torque nut to 450 lbs-ft. Install cotter
pin.
Figure 20. Crossbar Installation
Crossbar Timing
Crossbar must be re-timed anytime a crossbar or a
side drive is disconnected.
1. To re-time crossbars, position bars as shown in
Figure 21.
2. The right crossbar will be at right angles to the front
of the cutter.
3. Measure from the front of the cutter to the blade pin
on left crossbar.
4. Hold crossbars in position while connecting the
side drivelines.
Figure 21. Crossbar Timing - Bottom View