Filter
Top Products
40 Assembly
MAN0810 (9/24/2009)
Install Chain or Belt Shielding
Full chain shielding must be installed when
operating in populated areas or other areas where
thrown objects could injure people or damage
property.
• If this machine is not equipped with full chain
shielding, operation must be stopped when any-
one comes within 300 feet (92 m).
• This shielding is designed to reduce the risk
of thrown objects. The mower deck and protec-
tive devices cannot prevent all objects from
escaping the blade enclosure in every mowing
condition.
It is possible for objects to ricochet
and escape, traveling as much as 300 feet (92 m).
Install chain and rubber shields with hardware as
shown. (Refer to Figure 33 for Chain Shielding Installa-
tion; Figure 35 and Figure 36 for Belt Shielding Installa-
tion.)
NOTE: Chain Shielding:
Install four (two per wing) 4-
link chain sections (16) to the wing skid shoes. Secure
with carriage bolts (19) and flange lock nuts (21).
Figure 33. Chain Shielding Installation - Center Section
1. Front Center Chain Plate
2. Front Right Chain Plate
3. Front Left Chain Plate
4. Rear Chain Plate, Inner
5. Rear Chain Plate, Outer
10. Pin, 9 to 11 Chains
11. Pin, 13 to 15 Chains
13. Pin, 19 to 21 Chains
14. Pin, 22 to 24 Chains
16. 5/16 Chain - 4 Link
17. 5/16 Chain - 5 Link
18. 5/16 Chain - 11 Link
20. 3/8 NC x 2 HHCS
22. 3/8 NC x 1 Carriage Bolt
GR5
23. 3/8 NC Flanged Lock Nut
(Rev. 3/3/2010)