Filter
Top Products
10 Assembly
29929 (Rev. 3/28/2008)
ASSEMBLY
Assembly of this mower is the responsibility of the
Woods dealer. It should be delivered to the owner com-
pletely assembled, lubricated, and adjusted for normal
cutting conditions.
Refer to mower frame assembly illustrations and parts
list. Lay out parts and hardware on a clean surface to
aid in assembly.
■ Keep all persons away from the operator con-
trol area while performing adjustments, service or
maintenance.
■ Always wear relatively tight and belted clothing
to avoid entanglement in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hands, hearing and head.
Side Shields (See page 16)
Attach side shields to the mower with 3/8 x 1" cap
screws and flange lock nuts. A side discharge chute
(60) may be installed on the right end of the mower in
place of side shield (54).
Center Belt Shield (See page 16)
Bolt center belt shield bracket (21) to mower deck in
hole just behind center spindle using 3/8 x 1" bolt, lock
washer and nut. Bolt center shield (22) to this bracket
and to deck, using the three bolts welded in them.
Secure with 3/8" nuts and lock washers.
Side Skids (See page 16)
Bolt the side skids on in such a position that they will be
carried close to the ground when the mower is oper-
ated at the desired mowing height. Use 3/8 x 1-1/4 heat
treated bolts (torque to 35 lbs-ft) lock washers and
nuts.
Fast Hitch
To use 59CLF-4 with Fast Hitch, accessory kit 10570
must be used.
Figure 1. Photo of Mounting Plate Supplied in 10570
and Installation of Attachment Bracket
Figure 2. 59CLF-4 with Fast Hitch Shown Mounted
on Cub Lo-Boy Tractor with all of the
Fast Hitch Equipment Installed
Remove the drawbar mounting plates for the Fast Hitch
from the Fast Hitch. Replace with special mounting
plates supplied in the kit.
Front Toe Guards (See page 16)
Front toe guards (59) are furnished for some mowers.
When provided, bolt them to front of mower, using 3/8
NC x 3/4" carriage bolts and 3/8" flange lock nuts.
Attachment Arms
For tractors with fast hitch, see page 16. Bolt attach-
ment arms (31) and (40) to inside of drawbar mounting
brackets on the tractor with one 5/8 x 1-3/4" cap screw
and lock washer and one 1/2 x 2-1/2" cap screw, flat
washer, lock washer, and nut in each. If drawbar is not
used, place a 5/8 x 1-3/8 x 5/8" washer between verti-
AWARNING
ACAUTION