Filter
Top Products
Mount Installation 3
MAN0807 (6/17/2009)
LOADER MOUNT INSTALLATION
■ Only use 2104045 Loader Mounting Kit for
mounting Woods LS84 loader on Kubota
®
B3200
and B3300SU tractors. Any other use or modifica-
tion of this mounting kit may result in serious
injury or death.
Safety instructions are important! Read all
attachment and power unit manuals; follow all
safety rules and safety decal information. (Replace-
ment manuals and safety decals are available from
your dealer. To locate your nearest dealer, check
the Dealer Locator at www.WoodsEquipment.com,
or in the United States and Canada call 1-800-319-
6637.) Failure to follow instructions or safety rules
can result in serious injury or death.
Always wear relatively tight and belted clothing
to avoid getting caught in moving parts. Wear
sturdy, rough-soled work shoes and protective
equipment for eyes, hair, hands, hearing, and head;
and respirator or filter mask where appropriate.
NOTICE
■ This equipment must be assembled and
installed on the customer’s tractor by the Woods
dealer. Dealer must thoroughly inspect equipment
and complete each item on the PRE-DELIVERY
CHECK LIST, DELIVERY CHECK LIST, and PROD-
UCT REGISTRATION before equipment is released
to the customer.
■ Clean threaded holes in the tractor chassis
thoroughly using a tap of the proper size. Paint,
rust, or debris in the threads may not permit cap
screws to be installed and tightened correctly.
CAUTION
TRACTOR PREPARATION
For installing this mounting kit, references to right, left,
forward, and rearward directions are determined from
the operator’s position in the tractor seat.
NOTE: Leave all loader mount hardware loose until
mount is completely installed or otherwise instructed.
NOTE: 2104045 Loader Mounting Kit is compatible
with Kubota RCK 60-27BA and RC 72-27BA under-
mount mowers. See Kubota undermount mower man-
ual for installation instructions.
1. Shut off engine and set parking brake during
installation.
2. Remove the tractor front weights if equipped.
3. Set the tractor wheels to the manufacturer’s wid-
est recommended spacing. Refer to the tractor
operator’s manual.
4. Remove tractor sub-frame brackets from both
sides of the tractor, shown in Figure 1.
Figure 1
. Remove Tractor Front Sub-Frame Brackets
(B3200)
As a valued customer, Woods appreciates your comments. Once loader mount and
hydraulic hoses have been installed, please take a few minutes to complete the Loader
Mount Evaluation sheet that was supplied with your loader mount. Your comments will
help us continue to bring you quality products.
(Rev. 4/25/2011)